Naga Vutukury

Naga Jaswanth Vutukury
https://www.linkedin.com/in/naga-jaswanth-vutukury-399b6278

708 W 12th St (413) 561-8066
Rolla, MO 65401 nvf4d@mst.edu

Objective To obtain a full-time position as an Electrical Engineer

Education Missouri University of Science and Technology Aug 2013 – May 2016
M.S. Electrical Engineering GPA: 3.1/4.0

Osmania University Sep 2009 – May 2013
B.E. Electrical and Electronics Engineering GPA: 3.5/4.0

Experience Hitachi Americas Limited Farmington Hills, MI
R&D EMC Intern May 2015– Dec 2015•
•••Analyzed conducted emissions from high voltage inverter using co-simulation methodology
• •••Electromagnetic analysis focusing on noise propagation in inverter using ANSYS HFSS
• •••Recommended design changes for inverter based on conductive emissions simulation results
•••Assisted in EMC tests of Chevrolet Volt in RF screen room
•••Designed PCB board for pre-charging and discharging of DC block capacitors

Missouri University of Science and Technology Rolla, MO
Graduate Research Assistant Jan 2014 – Present•
•••Extensive use of CST and ANSYS HFSS for designing antennas and electromagnetic simulation models
•••Developed microwave sensors for detecting sand using N-type, SMA coaxial cables and Waveguides
•••Designed and developed horn antennas, patch antennas and conformal patch arrays
•••Designed waveguide connector for better impedance matching and to minimize reflections
•••Design and development of superstrate patch antennas for materials with high dielectric constant

EMC Laboratory Rolla, MO
Design of 23.5 MHz-40 GHz RF Signal Generator Jan 2015 – May 2015
•••Designed wide band signal generator from 23.5 MHz-6 GHz VCO-PLL with adjustable RF output power
•••Generated frequencies above 6GHz up to 40GHz using frequency doublers, splitters and filters
•••Designed high frequency PCB evaluation boards for splitter, frequency doubler and filter (20-40 GHz)

EMC Analysis and Interference Control in Electronic Systems Oct 2013 – Dec 2013
•••Designed a PCB board to meet FCC regulations
•••Measured radiation pattern with horizontal and vertical polarization
•••Compared radiation pattern of DUT with and without ferrites, pigtail and Rogowski coil

Student REC center Rolla,MO
Facility Supervisor Jan 2015 – Present
•••Monitored recreation facility, fitness center and supporting staff
•••Supported and enforced policies and procedures of recreation program

CAD Tools CST Microwave Studio ANSYS HFSS ANSYS Simplorer ANSYS Q3D
& Test Solidworks Agilent ADS Pspice Eagle
Equipment Cadence Spectrum Analyzer VNA Oscilloscope

Programming MATLAB C language C++
Publications Vutukury, J.N.; Donnell, K.M.; Hilgedick, S., “Microwave sensing of sand production from petroleum
wells,” Instrumentation and Measurement Technology Conference (I2MTC), 2015 IEEE International, vol.,
no., pp.1210, 1214, 11-14 May 2015

Hilgedick, S., J.N. Vutukury, and K.M. Donnell, “Application of Open-Ended Coaxial Probes for Detection
of Sand Production from Petroleum Wells”, Proceedings of the International Instrumentationand
Measurement Technology Conference, pp. 675-680, May 12-15, 2014, Montevideo, Uruguay

Activities IEEE – Student member
American Red Cross – Disaster action team member
Joe’s P.E.E.R.S – Certified peer educator

  • Updated 8 years ago

To contact this candidate email nvf4d@mst.edu

Contact using webmail: Gmail / AOL / Yahoo / Outlook

This entry was posted in . Bookmark the permalink.